Glossary entry (derived from question below)
English term or phrase:
passing bridge
French translation:
prise en charge des paquets IPv6 sur la passerelle (le pont) de transfert fonctionnant sous IEEE 802
Added to glossary by
GILLES MEUNIER
Nov 11, 2013 08:03
10 yrs ago
English term
France
passing bridge
English to French
Tech/Engineering
Computers: Systems, Networks
This allows for backward compatibility with pre-existing IPv6 protocol implementations as well as for support of IEEE 802-based passing bridge IPv6 packets
Proposed translations
(French)
| 4 | prise en charge des paquets IPv6 sur la passerelle (le pont) de transfert fonctionnant sous IEEE 802 |
GILLES MEUNIER
|
| 4 | transmission des paquets IPV6 en mode pont |
FX Fraipont (X)
|
Change log
Nov 20, 2013 15:34: GILLES MEUNIER Created KOG entry
Proposed translations
12 mins
Selected
prise en charge des paquets IPv6 sur la passerelle (le pont) de transfert fonctionnant sous IEEE 802
http://technet.microsoft.com/fr-fr/library/bb726952.aspx
--------------------------------------------------
Note added at 12 minutes (2013-11-11 08:16:50 GMT)
--------------------------------------------------
backward compatibility = rétro-compatibilité
--------------------------------------------------
Note added at 12 minutes (2013-11-11 08:16:50 GMT)
--------------------------------------------------
backward compatibility = rétro-compatibilité
4 KudoZ points awarded for this answer.
Comment: "merci !"
2 hrs
transmission des paquets IPV6 en mode pont
bridge ≠ gateway
"A GeoAdhoc router where the GeoNetworking protocol runs on top of a link-layer protocol that supports an integration function [29] for passing bridge packets, shall provide at least one virtual interface that supports the same integration function at least for passing bridge IPv6 packets.
The above clause does not require an GeoAdhoc router to implement full bridge functionalities. It requires these functionalities only for IPv6 packets. Furthermore, the above clause only applies if a standard integration function for passing bridge packets exists for the specific link-layer protocol on which the GeoNetworking protocol runs."
Est -il possible de configurer le DD-WRT V24 en ipv6 ?
"J'ai testé la méthode ci-dessous mais la règle "ebtables" est refusée , elle n'est pas supportée par le kernel du DD-WRT. Y a t-il une solution de remplacement ?
...
J'ai un WRT54GL v1.1, donc c vlan0 et vlan1 à la place de eth0,eth1.
on cree le bridge
brctl addbr br0"
http://www.dd-wrt.com/phpBB2/viewtopic.php?p=523645
"http://www.inetdoc.net/guides/vm/vm.network.tun-tap.htmlTranslate this page
Communications réseau en mode pont ... De même, cette interface au lieu d'envoyer les paquets vers un média physique, les ... errors:0 dropped:0 overruns:0 carrier:0 collisions:0 lg file transmission:500 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) ... (C) 1999-2004 Max Krasnyansky <[email protected]> tap0: no IPv6 routers ..."
on l'active
ifconfig br0 up
on ajoute le filtre pour limiter le bridge aux packets ipv6
ebtables -t broute -A BROUTING -p ! ipv6 -j DROP"
"A GeoAdhoc router where the GeoNetworking protocol runs on top of a link-layer protocol that supports an integration function [29] for passing bridge packets, shall provide at least one virtual interface that supports the same integration function at least for passing bridge IPv6 packets.
The above clause does not require an GeoAdhoc router to implement full bridge functionalities. It requires these functionalities only for IPv6 packets. Furthermore, the above clause only applies if a standard integration function for passing bridge packets exists for the specific link-layer protocol on which the GeoNetworking protocol runs."
Est -il possible de configurer le DD-WRT V24 en ipv6 ?
"J'ai testé la méthode ci-dessous mais la règle "ebtables" est refusée , elle n'est pas supportée par le kernel du DD-WRT. Y a t-il une solution de remplacement ?
...
J'ai un WRT54GL v1.1, donc c vlan0 et vlan1 à la place de eth0,eth1.
on cree le bridge
brctl addbr br0"
http://www.dd-wrt.com/phpBB2/viewtopic.php?p=523645
"http://www.inetdoc.net/guides/vm/vm.network.tun-tap.htmlTranslate this page
Communications réseau en mode pont ... De même, cette interface au lieu d'envoyer les paquets vers un média physique, les ... errors:0 dropped:0 overruns:0 carrier:0 collisions:0 lg file transmission:500 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) ... (C) 1999-2004 Max Krasnyansky <[email protected]> tap0: no IPv6 routers ..."
on l'active
ifconfig br0 up
on ajoute le filtre pour limiter le bridge aux packets ipv6
ebtables -t broute -A BROUTING -p ! ipv6 -j DROP"
Something went wrong...